Glue block

Today, by using this product, it is possible to prevent the creation of a thermal bridge and put different parts of the structure together with more speed and accuracy. The quality of building walls will be greatly increased with the help of this glue.

Advantages of using block glue

Today, by using block glue, the speed of preparing the structure will increase. This quality glue is ready to use in just 15 minutes. While a lot of time should be spent to prepare the mortar. It should be noted that two kilograms of glue is enough to cover every square meter of a structure.

This glue is made in the factory with the help of highly advanced equipment with automatic operation, therefore human power is not involved in the production of this product and the possibility of human error in its production process is very low. This product has a very high adhesion power, so after only 5 minutes, the structural blocks will be stuck together by this product.

This product can be used for long hours due to its high efficiency. Therefore, the workers can prepare this glue early in the morning and then use the same glue to place the blocks next to each other in an integrated and regular manner.

The walls will be built with the help of high-quality block glue, and the most orderly and safest building walls will be built with the help of this product. Today, with the help of the capabilities of this glue, there is no need to use traditional methods anymore, and the desired result can be achieved with just a thin layer of this glue.

How to use block glue

It is better to use a toothed trowel for better use of block glue. The wall made with this adhesive usually has a uniform and very smooth surface, so the necessary preparations for installing tiles, ceramics, plaster or plastering can be done immediately.

Today, the capabilities of this glue can be used in hot, dry or even moderate weather conditions. When using block glue, you should consider that the ambient temperature should not be lower than 10 degrees Celsius. If you are in a situation where the ambient temperature is around 5 degrees Celsius, then it is better to use hot water to prepare the glue so that the glue does not lose its properties.

Important points about using block glue

When preparing glue, you must use a specific amount of water; Because using less or too much water may reduce the adhesive strength of this product. Usually, if water is used less than the standard amount, then the glue will harden and the blocks will not connect well to each other. In addition, adding too much water will dilute the glue and reduce its capabilities.

After preparing the glue, you must first clean the surface of the blocks with a wet brush so that the thin layer of glue is well placed on the blocks. The presence of possible dust caused by building activity in the work environment reduces the adhesive strength of this product and reduces its efficiency.

Use a suitable notched trowel to stick the blocks together. Otherwise, you may use an extra and non-standard amount of glue to connect the blocks. The thickness of the glue should be within the standard range. If the adhesive layer is thinner than usual, then the blocks will not be connected to each other. In addition to this, the thickness of the adhesive layer also causes the wastage of the adhesive. At the same time, it disrupts the uniform and regular appearance of the walls.